15mm LDC Printed Parts For Beeman QB78, QB79 And Hammerli 850 Air Rifle

Description

15mm LDC Printed Parts For Beeman QB78, QB79 And Hammerli 850 Air Rifle
These are 3D printed parts to modify or build your own 15mm slip fit LDC.
These are good for everything up to and including .25 pellets.
These are designed to install in a 5” long 25x23mm carbon fiber tube. They will be to long for anything under 5”, but they are fine for lengths over sir.
Parts will come ready to install. All you need is a 25x23mm Carbon fiber tube and a few dabs of decent superglue.
Threads will be tapped and the bore will be reamed. The parts will be ready to go. A set screw and hex key are supplied.
This is not an LDC. I will not build and ship you a completed one. This is for 3D printed parts only.
Caps will all come in black. The core will not come in any specific color, they will be whichever color I have loaded up. The cores are all identical aside from color.
You will need to supply your own 25x23mm Carbon fiber tube and some super glue. Depending on the tube source, fitment may be a little snug or a little loose. Everything will tap into place with a soft mallet if it ends up snug. The end product is a super light and effective unit.
I will send instructions for my 5” design with these parts.
I have a listing for matte 25x23mm carbon fiber tube pre cut to 5” and ready to use. Please look at my other listings. Generally all 25x23mm carbon fiber tube will work if you can cut it square.
I am not responsible for misuse or mis-installation of these parts. These have been designed with plenty of room for everything up to and including .25 pellets.
It’s a shame I have to add this, but with the state of things today, I feel like I have to. These parts are 3D printed. They are designed for Airguns only. Any other use than intended could, and most likely result in catastrophic failure or personal injury.
This will ship free via USPS first class package.
I am on Gateway to Airguns as Austinbintx.